The different stages of testing is stored on its own page.
The first set of tests we performed is stored here.
The second sets of test we did is stored here.
The preliminary tests before starting final testing is stored here.
Tests on heart is stored here.
Tests on liver is stored here.
Tests on lung is stored here.
Tests on kidney is stored here.
Testing on Turkey Slices: Del 2
To define the effectiveness of the CNC and discover possible faults, we test ARTS 2.0 on turkey slices.
The setup has now been upgraded, and therefore no longer needs post-processing of the gcode.
Summary
| Slice | Settings | Status | Comments | Future change |
|---|---|---|---|---|
| 1 | Speed: 1mm/s Power: 100% Layer height: 0.50 |
Success | The last sample did not fall down | |
| 2 | Speed: 1mm/s Power: 100% Layer height: 0.50 |
Success | The last sample did not fall down | Increase layer height for bigger last cut |
| 3 | Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm |
Success | The first sample did not fall down. Had to change mill bit to Ø1.0mm |
Lower starting position height |
| 4 | Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm |
Success | The first sample did not fall down. | Lower starting position height |
| 5 | Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm |
Success | Two samples did not fall | Added drop-off after each sample in the code. |
| 6 | Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm |
Failure | Slice loosened No image |
|
| 7 | Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm |
Failure | Slice loosened | |
| 8 | Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm |
Success | ||
| 9 | Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm |
Success | Filmed | |
| 10 | Speed: 0.15mm/s Power: 100% Layer height: Full Mill bit diameter: 1.0 mm |
Success | First and third sample did not fall out | Automatically push out samples, instead of circkeling g above them |
| 11 | Speed: 0.15mm/s Power: 100% Layer height: Full Mill bit diameter: 1.0 mm |
Failed | Spindle was not activated after pushing. | Pushing with spindle activated. Several pushes on difficult geometry |
| 12 | Speed: 0.15mm/s Power: 100% Layer height: Full Mill bit diameter: 1.0 mm |
Success | Pushing is not perfect, because it is unpredictable where the slices will become stuck. |
|
