Document for console comands:
https://www.diymachining.com/downloads/GRBL_Settings_Pocket_Guide_Rev_B.pdf
Run/Cut Settings
Machine settings
Device Settings:
Console Settings: ($$-settings)
$$
$0=10
$1=25
$2=0
$3=0
$4=0
$5=0
$6=0
$10=2
$11=0.010
$12=0.002
$13=0
$20=1
$21=0
$22=1
$23=3
$24=25.000
$25=500.000
$26=250
$27=1.000
$30=1000
$31=0
$32=0
$100=800.000
$101=800.000
$102=800.000
$110=1000.000
$111=1000.000
$112=600.000
$120=30.000
$121=30.000
$122=30.000
$130=110.000
$131=70.000
$132=17.500
ok
$#-settings:
$#
[G54:-110.000,-70.000,0.000] (changing this, use: G10 L2 P1 X*insertNumber* Y*InsertNumber Z*insertNumber*)
[G55:0.000,0.000,0.000]
[G56:0.000,0.000,0.000]
[G57:0.000,0.000,0.000]
[G58:0.000,0.000,0.000]
[G59:0.000,0.000,0.000]
[G28:0.000,0.000,0.000]
[G30:0.000,0.000,0.000]
[G92:0.000,0.000,0.000]
[TLO:0.000]
[PRB:0.000,0.000,0.000:0]
ok
Camera Calibration Alignment Note:
70x70mm Gives 98% accurate result
