Testing on Turkey Slices: Del 2

To define the effectiveness of the CNC and discover possible faults, we test ARTS 2.0 on turkey slices.
The setup has now been upgraded, and therefore no longer needs post-processing of the gcode.

Summary

Slice	Settings	Status	Comments	Future change
1	Speed: 1mm/s Power: 100% Layer height: 0.50	Success	The last sample did not fall down
2	Speed: 1mm/s Power: 100% Layer height: 0.50	Success	The last sample did not fall down	Increase layer height for bigger last cut
3	Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm	Success	The first sample did not fall down. Had to change mill bit to Ø1.0mm	Lower starting position height
4	Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm	Success	The first sample did not fall down.	Lower starting position height
5	Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm	Success	Two samples did not fall	Added drop-off after each sample in the code.
6	Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm	Failure	Slice loosened No image
7	Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm	Failure	Slice loosened
8	Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm	Success
9	Speed: 0.6mm/s Power: 100% Layer height: 0.75 Mill bit diameter: 1.0 mm	Success	Filmed
10	Speed: 0.15mm/s Power: 100% Layer height: Full Mill bit diameter: 1.0 mm	Success	First and third sample did not fall out	Automatically push out samples, instead of circkeling g above them
11	Speed: 0.15mm/s Power: 100% Layer height: Full Mill bit diameter: 1.0 mm	Failed	Spindle was not activated after pushing.	Pushing with spindle activated. Several pushes on difficult geometry
12	Speed: 0.15mm/s Power: 100% Layer height: Full Mill bit diameter: 1.0 mm	Success	Pushing is not perfect, because it is unpredictable where the slices will become stuck.