This page documents the Version 1, Revision 1 (V1R1) electronics design of the hyperspectral imager. If you are working on the firmware or integration of the HSI payload, you should find everything you need here (when it is finished).
Introduction
Usually the goal of the first prototype revision is to get data as soon as possible, but in this case Fred Sigernes's v4 and v5 cameras are giving us data for testing and verification. The goal of this prototype is to get the entire processing chain up and running with image sensor and on-board processing, and to get a better understanding of the challenges involved in hyperspectral imager hardware development. Because the satellite bus is unknown at the time of the design, it's intended for desktop- drone- and balloon-testing.
Full Assembly
| Carrier Board | Carrier Board + Optics | Carrier Board + Optics + FPGA Board |
|---|---|---|
 |  |  |
...
Technical Specifications
Resolution: 2048x1088
Storage: 36GB (4GB eMMC + 32GB microSD)
Memory: 1GB
Processor: Dual Core ARM A9 (Zynq 7030 Series FGPA)
Input Voltage: 4.5-14.5V
Maximum current: 6A
USB 2.0
System Design
Power Supply
...