A very short and simplified procedure for designing a foil in 3D. Foil geometry can be based on NACA-profiles or just an ellipse as used in this example. Profile sections are defined in two or more sketches and then conencted by using Through Curves.

  1. Create two or more sketches defining the foil geometry.
  2. Connect sections by using Through Curves. Make sure you are adding each sketch (curve) as a new section in the section list.
Sketch 1
Sketch 1 and Sketch 2
Sketch 1, Sketch 2 and Sketch 3
Sketches from top view
Each curve as a new section in section list.
Foil